Herunterladen Diese Seite drucken

Controls And Indicators; Key/Light Switch; Direction Selector; State Of Charge Meter - E-Z-GO MPT 800 Bedienungs- Und Wartungshandbuch

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
If vehicle is to be charged with a non E-Z-GO charger, refer to
the instructions supplied with the charger.

CONTROLS AND INDICATORS

Vehicle controls and indicators consist of:

key/light switch

direction selector

state of charge meter

hour meter

accelerator pedal
combination service and park brake pedal
horn
KEY/LIGHT SWITCH
Located on the dash panel, this switch enables the basic
electrical system of the vehicle to be turned on and off by
turning the key. To prevent inadvertent operation of the
vehicle when left unattended, the key should be turned to
the 'OFF' position and removed (Ref Fig. 5 on page 3).
Ref Kes 4
Fig. 5 Key/Light Switch & State of Charge Meter
If the vehicle is equipped with lights, the key switch has a
position to operate them, indicated by the light icon.
If the vehicle is equipped with manufacturer installed custom
accessories, some accessories remain operational with the key
switch in the 'OFF' position.
OPERATION AND SERVICE INFORMATION
Key/Light Switch
State of Charge Meter
Owner's Manual and Service Guide
DIRECTION SELECTOR
To prevent loss of control, do not move Preci-
sion Drive System (PDS) vehicle direction
selector while the vehicle is in motion. Moving
the selector will result in a sudden slowing of
the vehicle and the beeping of a warning
device.
To reduce the possibility of component damage, the
vehicle must be completely stopped before moving the
direction selector.
On PDS models, if the direction selector is shifted before
the vehicle comes to a complete stop, a warning beeper
will activate.
Located on the seat support panel or the dash panel, this
lever or switch permits the selection of either 'F' (for-
ward), 'R' (reverse) or neutral (the position between for-
ward and reverse). Vehicle should be left in neutral with
park brake applied/locked when unattended (Ref Fig. 6
on page 3).
FWD
REV
Forward
Reverse
Neutral, as shown
ef Dsl 1
Fig. 6 Direction Selector Types
STATE OF CHARGE METER
Located in the dash, the state of charge meter indicates
the amount of usable power in the batteries (Ref Fig. 5
on page 3).
HOUR METER
The hour meter indicates total hours of operation.
Neutral
Reverse
Forward
Page 3

Werbung

loading

Diese Anleitung auch für:

Industrial 1000Mpt 1000Industrial 800