Unox BakerTop XBC series Bedienungsanweisung Seite 49

Gas connections
Gas Setup
The gas type in the gas pipe network must be checked by a qualified technician that, if necessary, replaces
the nozzle, adjusts the primary air and sets the type of gas on the oven control panel and apply the label.
Nozzle replacement and primary air adjustment
Using the table in the attached technical data sheet, replace the main injector and adjust the primary air using
the corresponding bushing. This procedure should only be carried out once the gas valve upstream of the
oven has been shut off and the power supply disconnected. Make sure that the diameter measurement of the
injector to be replaced is stamped on it, in hundredths of a millimetre (1/100 mm). The injector is located at
the rear, on the bottom left-hand side. To replace the injector and adjust the primary air, proceed as follows
(see illustration below):
There are 2 types of nozzle:
- one suitable for G20, G25 and G25.1 gas
- one suitable for G30 and G31 gas
OVEN
G20, G25, G25.1
XBC 615 G
G20, G25, G25.1
XBC 815 G
G20, G25, G25.1
XVC 315 G
G20, G25, G25.1
XVC 515 G
G20, G25, G25.1
XVC 715 G
G20, G25, G25.1
XVC 1215 G
G20, G25, G25.1
XVC 2015 G
G20, G25, G25.1
XVC915G - XVC1015G
XBC915G - XBC1015G
G20, G25, G25.1
XVC3215G - XVC4015G
• Loosen screw A.
• Adjust bushing B in accordance with the information provided in the
attached table.
• Unscrew and remove injector C using a 13 mm spanner.
• Install the injector most suited to the type of gas supplied (see relevant
technical table).
• Position bushing B at the correct distance H (see relevant technical table).
• Re-tighten screw A.
GAS NOZZLE CODE
BR1275A0
G30,G31 BR1055A0
UG1001A0
G30,G31 BR1250A0
BR1020A0
G30,G31 BR1085A0
BR1270A0
G30,G31 BR1150A0
BR1280A0
G30,G31 BR1180A0
BR1275A0
G30,G31 BR1055A0
UG1001A0
G30,G31 BR1250A0
BR1245A0
G30,G31 BR1055A0
BR1245A0
G30,G31 BR1055A0
49
ChefTop
™
NOZZLE DIAMETER PRIMARY AIR
[1/100 mm] L [mm]
345
All open
L=39 mm
225
375
All open
L=39 mm
245
280
All open
L=39 mm
185
335
All open
L=39 mm
220
360
All open
L=39 mm
230
345
All open
L=39 mm
225
375
All open
L=39 mm
245
355 L=39 mm
All open
225
L=39 mm
355 L=39 mm
All open
225
L=39 mm
BakerTop
™
INSTALLATION
In the appliance
Installed
In the appliance
Installed
In the appliance
Installed
In the appliance
Installed
In the appliance
Installed
In the appliance
Installed
In the appliance
Installed
In the appliance
Installed
In the appliance
Installed
English