Unox BakerTop XBC series Bedienungsanweisung Seite 37

Positioning
Door closure regulation
Models without trolley
If, once the oven is in position, the door handle does not remain in its correct closed position (Fig. 1), the
closure latch probably needs to be adjusted; proceed as follows:
• while the oven door is open (Fig. 2), slightly loosen the screws fixing the latch in place (Fig. 3);
• close the door again and turn the handle to stop it from opening (Fig. 3);
• if the door stays shut with the handle in a perfectly vertical position, open the door again (Fig. 4) and tighten
the latch fixing screws (Fig. 5);
• if the problem persists, repeat this procedure, loosening the latch fixing screws further.
1
Trolley models
In case, once the oven has been placed, the door handle of the oven does not correctly close in vertical
position (pic.1), it may be necessary to fix the door spring latch position. Proceed as follows:
• open the oven door and loose the upper and lower spring latch fixing screws (pictures 2 and 3)
• lightly loose the 2 central spring latch fixing screws (picture 4)
• draw the door up to the spring latch and move vertically the position of the latch in order to make it
perfectly lined up with the door closing pin (picture 5)
• tight the upper, lower and central spring latch fixing screws and try to close the door.
• if the door closes properly and the handle perfectly stays in vertical position, open the door and tightly
fix the fixing screws of the latch.
• in case the problem is not solved, repeat the procedure and loose more the spring latch fixing screws .
1
N.B
A support surface which is not perfectly even will not allow the door handle to close correctly: if the surface is
only slightly uneven, the problem may be overcome by adjusting the closure latch using the method described
previously; there is no way of compensating for a highly uneven floor or oven support surface.
ChefTop
2 3
2 3
37
BakerTop
™
4 5
4 5
English
™