Standard Functions; Lastp Function; Automatic Washing Programs - Unox BakerTop XBC series Bedienungsanweisung

Standard functions

LASTP function

This can be used to quickly select the most recently used cooking cycle, whether it was activated manually or
in programmed mode.
When the cooking cycle has finished, press the
Press the button to start the most recently used cooking cycle again.

Automatic washing programs

The Rotor.KLEAN™ washing system, code XC405, offers automatic washing of the oven cavity. Automatic
washing programs can only be used if the appliance features this option. The Rotor.KLEAN™ washing system
may also be installed after the appliance has been commissioned.
3 washing programs (SHORT WASHING, MED WASHING and LONG WASHING) are stored in the control
P .C.B. memory, as well as a pre-loading program for the detergent and rinse aid pipes (PUMP LOADING).
There are another two semi-automatic programs: "LH2O", which can be used to rinse and dry the oven cavity
at a temperature of 120°C, without the use of chemicals and "SEMI-AUTOMATIC WASHING" which can
wash the oven cavity using a pre setted temperature and chemicals products manually.
Access the programming menu by pressing the
-
-
+
Press the buttons repeatedly until the LH2O, SHORT WASHING, MED WASHING, LONG WASHING
or PUMP LOADING washing programs appear on display 5;
Press the button to start the selected program;
N.B.
The first time the washing system is used, it is advisable to run the PUMP LOADING program to remove any
air inside the detergent and rinse aid pipes, so that the quality of the wash is not compromised.
These programs are only used if the Rotor.KLEAN™ washing system (XC405) is installed.
Caution!
We recommend the oven cavity is cleaned on a daily basis, in order to maintain acceptable hygiene standards and
to prevent the stainless steel inside the cavity from being ruined. We would therefore recommend the use of the
Rotor.KLEAN™ washing system, code XC405, which offers automatic washing of the oven cavity. Caution!
If the appliance is not cleaned or not cleaned thoroughly enough, grease or remnants of food which have accumulated
inside the oven cavity may start to burn - fire hazard!
To prevent corrosion from occurring inside the oven cavity, the appliance should be cleaned every day, even if it is only
used for steam cooking purposes.
Only use detergents which have been recommeded by the appliance manufacturer. Detergents from other manufacturers
may damage the appliance and therefore invalidate the guarantee.
Caution!
Never open the oven cavity door while a cleaning cycle is in progress - chemical cleaning substances and hot air may escape
- risk of corrosion and burns! When the cleaning cycle implemented by the Rotor.KLEAN™ system is complete, make sure
that there is no detergent residue remaining in the oven cavity (including the area behind the air channel panelling). Remove
any residue and rinse the entire oven cavity thoroughly (including the area behind theair channel panelling) using a hand-held
shower head - risk of corrosion!
English
button. The text "LASTP" will appear on display 5;
a a at tu u u
button;
22