Oven-User Communication; Warning Messages - Unox BakerTop XBC series Bedienungsanweisung

Oven-user communication

The digital control panel used in ChefTop™ - BakerTop™ ovens is designed to offer a straightforward interface
between the oven and the outside world, by means of existing communication systems and those to be used in the
future: USB, Bluetooth, serial port etc.
The USB XC236 interface kit can be used to carry out the following functions:
• entering cooking programs
• modifying operating parameters (e.g. probe calibration)
• diagnosing malfunctions
• storing oven cavity or blast chiller temperature changes in the memory of the appliance (data required for the HACCP system)
Further information is supplied with the kit.

Warning messages:

When a malfunction is detected which allows the appliance to continue operating, abeit in a limited manner, a
WARNING message is displayed.
The device continues to run and the WARNING message remains on the display until the
Warning messages oven:
Display message
An error has been detected in the data recorded by
WF01
cavity probe 1
An error has been detected in the data recorded by
WF02
cavity probe 2
An error has been detected in the data recorded by
WF03
the core probe
WF04
Non correct fan rotation speed
An error has been detected in the cooling system for
WF05
the electronic components
The temperature of the oven power P .C.B. is too
WF06
high
WF08
Gas board detected while the oven is set as electric
WF09
Error on the motor breaking system
WF10
Non basic power board setting error
WF11
Not correct temperature on the gas board
Too high temperature on the external thermocouples
WF12
board
WF13
The external sous-vide probe takes non correct data
Error on the data taken by the Multi.point core probe
WF14
(totally not working)
Error on the board-thermocouples communication
WF15
system
Error on the data taken by the Multi.point core probe
WF17
(partially not working)
English
Description
The oven contines to operate, using the data
from cavity probe 2 only
The oven contines to operate, using the data
from cavity probe 1 only
It is not possible to set steps or activate
programs which use the core probe; if a step
which uses the core probe is in progress, the
following step will begin
Turn off the motor breaking system
The cooling fan for the electronic components
may not work
There is a risk of permanent
damage to the power P .C.B.
The oven keeps on working but is controlled
as electric
The oven keeps on operating but the motor
breaking system is not working
The oven keeps on working (with some
limitations due to the setting involved on the
error)
The oven keeps on operating
The oven keeps on operating
The oven keeps on working but it is not possible
to use external sous-vide probe
The oven keeps on working but it is not possible
to use cooking programs with the core probe
The oven keeps on working but it is not possible
to use external sous-vide probe
The oven keeps on working but the core
temperature may be not precisely taken
28
Effect Problem solution
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Make sure the positioning standards
specified in the installation manual have
been observed. Contact the Customer
Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
button is pressed.