Inhaltsverzeichnis
Werbung
Tempo
Sets the arpeggiator's basic tempo. Can be defined manually in BPM (beats per minute) or
via MIDI clock, if extern is selected.
The arpeggiator can be used as a master as well as a slave via the MIDI clock:
• When you use the arpeggiator as the master, set its speed via the Tempo parameter.
Set the global parameter MIDI Clock Send to on . This enables the sending of MIDI
clock signal via the MicroWave II/XT/XTk's MIDI out jack
• When you use the arpeggiator as a slave, an external device (e.g.sequencer)
determines the tempo of the arpeggiator. Set the Tempo parameter to external as
described above. Here, too, notes and MIDI clock information can be used to
control other devices. In this mode, the MIDI Song Position Pointer is also
recognized.
Clock
Determines the note value for whole notes to thirty-second notes. The basis is a 4/4 beat.
Triplets (e.g. 1/8T ) and dotted notes (e.g. 1/16. ) are available for every value.
Range
Determines the range of the single notes in octaves.
Pattern
Determines whether an rhythm pattern is played and which one.
• If off is selected, the arpeggiator playes its notes in regular steps, specified by the
Clock parameter.
• If user is selected, the arpeggiator uses the free programmable pattern defined in
the Arpeggiator User Pattern page.
• Additionally, the arpeggiator features 15 preset rhythm patterns. These are
numbered from 1 through 15 . Here is an overview of the arpeggiator preset
patterns:
User's Manual MicroWave II • MicroWave XT • XTk
extern / 50...300
1/1...1/32
1...10
off / user / 1...15
Pattern
1
2
3
4
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Diagram 4: Arpeggiator patterns
6
7
8
9 10 11 12 13 14 15 16
.
69
Werbung
Inhaltsverzeichnis
