Analog Input - Waldorf MicroWave XT Bedienungsanleitung

Follow these steps to connect the devices:
• Turn all units off.
• Connect the MicroWave II/XT/XTk's main audio outputs Main Out Left/Stereo
and Main Out Right/Mono
auxilliary audio outputs Sub Out Left/Stereo
too.
• Connect your keyboards MIDI Out jack to the MicroWave II/XT/XTk's MIDI In jack
. If you own a XTk, you can use the internal keyboard.
• Connect the included adapter to the MicroWave II/XT's Power Supply
and fix the wire with the cable clip beside the socket. The XTk model does not
need an ac adapter an can be connected to a wall outlet directly.
• Insert the adapter plug in a suitable wall outlet (MicroWave II or XT only).
• First switch on the connected MIDI keyboard (if any) and then the mixing console
and amp.
If you do not choose to connect a mixing console, you can patch the MicroWave
II/XT/XTk's output signals directly to an amp. Use an input usually called Aux or Tape
input. If you do not want to send a stereo signal, use the Main Out Right/Mono
output. If you do not insert a plug into Main Out Left/Stereo
master signal is routed via the right output.
Before connecting and disconnecting the MicroWave II/XT/XTk to a power supply
source, turn your amp's volume control all the way down to avoid damage due to
on/off switching noise.
The MicroWave II/XT/XTk produces a high level output signal (see technical data).
Please take care that the connected playback device is suitable for the high level of
an electronic instrument.
Never use the mic or phono input of the connected amp!

Analog Input

The MicroWave XT and XTk provides an Analog In jack
external signal into the mixer section. Therefore, the signal can be processed via the filters
and the effects section in the same way as the oscillators.
As the external signal is treated like any other sound source within the MicroWave
XT/XTk, it is necessary to trigger the Amplifier Envelope to get the signal passed
through. To do so, notes must be sent to the MicroWave XT/XTk's sound generation,
either by receiving MIDI notes, the XTk's keyboard or via the internal arpeggiator.
User's Manual MicroWave II • MicroWave XT • XTk
to your mixing console. Optionally connect the two
and Sub Out Right/Mono
that can be used to feed in an
socket
, then the mono
15