Waldorf MicroWave XT Bedienungsanleitung Seite 46

EnvVelAmt
Determines the amount of influence the wave envelope has on the wavetable modulation,
based on key velocity. In conjunction with EnvAmount you can create nice effects when
you set one of the two parameters to a negative setting while the other one is set to a
positive setting.
Keytrack
Determines the amount of wavetable modulation depending on the received MIDI note
number. Reference note for this parameter is E3, note number 64. For positive settings the
modulation amount is increased for notes above to reference note, for negative settings the
amount is decreased. A setting of +100% corresponds to a 1:1 scale. This means that each
note above or below the reference note plays a different wave. E.g., when you set
Startwave to 29 and Keytrack to +100% , it means that E3 plays wave 29, F3 plays wave
30, F#3 plays wave 31 and so on.
Limit
This setting prevents, if enabled, accessing the analog type waveforms triangle, square and
sawtooth in any case of modulation. When disabled, the full modulation amount will be
calculated and applied so that the whole wavetable will be used for tone generation.
46
-64...+63
-200%...+197%
off / on
User's Manual MicroWave II • MicroWave XT • XTk