Waldorf MicroWave XT Bedienungsanleitung Seite 75

Level 1...8
End level that the corresponding segment finally reaches.
Key On Loop
Selects whether a loop is performed in the envelope's sustain phase or not.
Loop Start
Defines the starting point for the sustain loop if Key On Loop is enabled.
Loop End
Defines the ending point for the sustain loop if Key On Loop is enabled. It further
determines the end of the sustain phase and the beginning of the release phase. Note that
this feature is also valid when Key On Loop is disabled.
Key Off Loop
Selects whether a loop is performed in the envelope's release phase or not.
Loop Start
Defines the starting point for the release loop if Key Off Loop is enabled.
Loop End
Defines the ending point for the release loop if Key Off Loop is enabled. It further
determines the last segment of the whole envelope. No segment beyond the selected
number will be used. Note that this feature is also valid when Key Off Loop is disabled.
The loop points are numbered from 1 to 8. Each number represents the end of the
corresponding segment, e.g. no. 3 means the point of Level 3 after Time 3. As you
can see, the first loop point is at the end of segment 1. Therefore segment 1 can not
be looped.
The following examples illustrate the use of the Wave Envelope:
This is how you setup an classic ADSR-like envelope:
1. Set Key On Loop and Key Off Loop to off . This ensures that no loops are
performed.
2. Set Level 1 to 127 .
3. Specify the Attack time via the Time 1 parameter.
4. Specity the Decay time via Time 2.
5. Use Level 2 to setup the Sustain level.
6. Set Key On Loop Start to 1 and Key On Loop End to 2 . This specifies segment
2 of the envelope as last segment in the sustain phase.
7. Set Level 3 to 0 .
8. Specify the Release time via Time 3.
9. Set Key Off Loop End to 3 . This causes the envelope to stop after segment 3.
User's Manual MicroWave II • MicroWave XT • XTk
0...127
off / on
1...8
1...8
off / on
1...8
1...8
75