Inhaltsverzeichnis
Werbung
Please note that – like any usual edits – you have to store your modified programs to
make the changes permanent.
Panic Function
The Panic function sends and executes an "All Notes Off" command. It is used to terminate
stuck notes. To activate this function, briefly press the Power button
Panic will also stop the arpeggiator playing when running in Hold mode. Panic will
immediately set all envelopes to their release phases. When holding the button a bit longer,
all sound is suppressed and the release phases are overridden.
Randomizing a Program
This functions initializes all parameters of a Sound Program with random values.
This is how you randomize a program:
1. Press and hold the Shift key
2. Briefly press the Utility key
3. Release the Shift key
4. The display shows a page where you can select some utility functions. Most of
them are dump functions. Turn the page dial
Randomize
5. Briefly press the Utility key
The selected program is now randomized.
When you randomize a program, all action takes place inside an edit buffer.
Therefore no data will be lost until you store the program.
Initializing Programs
The MicroWave II/XT/XTk provides a special function for setting all parameters of a Sound
or Multi program to initial values. You can use it to create a program from the scratch.
This is how you initialize a program:
1. Press and hold the Shift key
2. Briefly press the Utility key
3. Release the Shift key
4. The display shows a page where you can select some utility functions. Most of
them are dump functions. Turn the page dial
Init Sound
30
.
.
.
Randomize
A001
[confirm with <Shift-Utility>]
while holding the Shift key
.
.
.
Init Sound A001
[confirm with <Shift-Utility>]
User's Manual MicroWave II • MicroWave XT • XTk
. Note that using
clockwise until the display shows:
Saw Repeat
WMF ?
again.
clockwise until the display shows:
Saw Repeat
WMF ?
Werbung
Inhaltsverzeichnis
