Waldorf MicroWave XT Bedienungsanleitung Seite 17

1. First, switch back to program A001 Saw Repeat WMF .
2. Press the Play button
parameters that by adjusted directly via the corresponding value dials:
3. Use the value dials to change the sound parameters and listen to the effect on the
generated sound. Actually, you can define the parameter set in this page on your
own. This is described later in the manual.
Comparing edited and original Program
You may always check your modifications against the original version of the program.
Though you can decide whether editing is going the right way or not.
1. Press the Compare key
2. The MicroWave II/XT/XTk now uses the original parameter values as they were set
before editing was applied. The display also shows these values. Play some notes to
listed to the unedited sound.
3. Press the Compare key
back to the edited sound program.
Recalling Edits
If you don't like the changed sound program, you can void the edits at any time and return
to the original.
To do so, press the Recall key
Storing Programs
After editing the program you have to store it to keep the changes permanent.
1. Press the Store key
2. Use the rightmost value dial to select a memory location for the edited sound. You
can also leave the setting as it is. In this case you're going to overwrite the original
sound program. Don't do it here, we will need it further on in this tour.
3. Press the Store key
permanently memorized.
Doing further Edits
We are now moving deeper into the sound editing capabilities of the MicroWave II/XT/XTk.
In the next steps we will show you how specific parameters act on the MicroWave
II/XT/XTk's behaviour. At first we like to play along with the filter.
1. Switch back to sound program A001 Saw Repeat WMF .
2. Press the second parameter select key
Recall function, but in this case, it is used without the Shift key
changes to show the parameter page for Filter 1:
User's Manual MicroWave II • MicroWave XT • XTk
F1 Cutoff|F1 Reso
092 | 000
while holding the Shift key
Store Sound
Saw Repeat
while holding the Shift key
again to access this page. The display then shows 4 sound
|F1 EnvAmt|FE Decay
| +29
while holding the Shift key
while holding the Shift key
while holding the Shift key
A001
WMF
. This is the same key that is used for the
| 084
.
again. This brings you
.
. The display now shows:
A001 ?
again. Your program is now
. The display
17