The Play Access Page - Waldorf MicroWave XT Bedienungsanleitung

5. Use the second value dial to select the store type:
6. Select the destination program. The default value is the currently selected program
but you may want to change it to store your edits under a different location. This
setting is not available if you choose All Edits for the store type.
7. Briefly press the Store key
Whenever you store a program, the selected memory location is overwritten.
Therefore, any previously stored program under this location will be erased and there
is no way to get it back. So, if you want to keep your factory presets you should
dump them to a computer for external storage.
You now have stored the program. When you activate the store function, the Edit or
Compare status of the stored program is terminated.
By pressing any key before performing the last step, you can discard the Store process at
any time.
Use the Store function also if you want to copy programs. There is no need to edit a
program before storing it.

The Play Access Page

The Play Access page is a very exciting feature that gives you an easy accessible control
over 4 freely definable Sound parameters. To select these parameters, please read the
corresponding paragraph in the chapter "Sound Parameters" later on in this manual.
This is how you access the parameters in the Play Access page:
1. When in Play mode, press the Play button
The display now shows:
Play Access
2. Use the value dials
3. Press the Play button
program select page. You can also you turn the page dial
program directly.
When the MicroWave II/XT/XTk is in Multi mode, the Play Access page always corresponds
to the Sound program of the currently selected Instrument.
User's Manual MicroWave II • MicroWave XT • XTk
• If Sound is selected, the current Sound program will be stored. When used
in Multi Mode, the Sound program of the currently selected instrument will
be stored.
• If Multi is selected, the current Multi Program will be stored. The Sound
programs that built the Multi are not stored by this task. You must do this
separately or by using the All Edits option. This setting is available in Multi
mode only.
• If All Edits is selected, the MicroWave will store back all edit buffers into
their original memory locations. Use this setting to save all edited programs
with a single task.
F1 Cutoff|F1 Reso
092
to change each parameter's value.
again to leave the Play Access page and return to the
while holding the Shift key
again to call the Play Access page.
|F1 EnvAmt|FE Decay
| 000 |
again.
+29 | 084
to select another
29