Waldorf MicroWave XT Bedienungsanleitung Seite 70

Direction
Determines the sequence of generated notes according to pitch.
• If up is selected, the arpeggio starts at the lowest note and sweeps up through the
notes until it reaches the highest note. It then starts at the bottom again.
• If down is selected, the arpeggio starts at the highest note and sweeps down
through the notes until it reaches the lowest note. It then starts at the top again.
• If alternate is selected, the arpeggio starts at the lowest note and sweeps up through
the notes until it reaches the highest note. It then starts to sweep back down.
• If random is selected, the arpeggio plays any of the notes in a random order.
NoteOrder
Determines the sequence of generated notes according to note order.
• If by note is selected, the arpeggio sequence is sorted by the MIDI note number.
This is the standard mode, used by most arpeggiators.
• If note rev. is selected, the arpeggio sequence is sorted in the exactly reversed
order to the by note setting.
• If as played is selected, the arpeggio is generated in the order of the incoming
notes. In combination with the user programmable pattern this feature offers a
small but effective step sequencer.
• If reversed is selected, the arpeggio is generated in the reverse order of the
incoming notes.
To understand the difference of the individual settings, it is nessessary to "step-input" the
notes of the chord as described at the beginning of this chapter.
Velocity
Determines how the velocity values of the generated notes are calculated.
• If root note is selected, every generated note inherits its velocity from its base note.
E.g. if the base chord for the arpeggio contains an E with a certain velocity, all
generated E notes also have this velocity value, independent of their octave setting.
• If last note is selected, every generated note has the same velocity as the last
incoming note.
Reset on Pattern Start off / on
Selects if the arpeggiator is reset each time the rhythm pattern starts again. If the setting is
disabled, the arpeggiator plays all chord notes from the first to the last and over again,
regarding the sequence determined by Direction and Note Order. If the setting is enabled,
the arpeggiator only plays the number of chord notes that correspond to the pattern length.
Then it starts with the first chord note at its basic octave again. The result is similar to
pressing the chord again each time the pattern restarts. If no pattern is selected, this
parameter has no function.
Length
Determines the length of the user programmable rhythm pattern.
70
up / down / alternate / random
by note / note rev. / as played / reversed
root note / last note
1...16
User's Manual MicroWave II • MicroWave XT • XTk