Waldorf MicroWave XT Bedienungsanleitung Seite 95

Control W...Control Z
These parameters are used to define modulation sources that are freely definable MIDI
controllers. Each value represents a MIDI controller number that is used when you assign
its parameter as modulation source in the Modifiers or the Modulation Matrix. The settings
made here are only valid for Sound programs because each Multi program has its own set
of Control W...Control Z parameters.
Example: You want to control the LFO1 speed via MIDI controller #49. To do so, set
Control W to 49 first. Then, setup an entry in the Modulation Matrix of your sound
program with Control W as source and LFO1 Rate as destination and apply an
suitable amount. In the same way you can use Control X...Control Z for further
assignments.
KB Send
Sets the MIDI send channel for the XTk keyboard. If the XTk is in Multi mode, the Multi
parameter MIDI Send determines whether the global channel set by this parameter is used
or the specific channel of the currently selected instrument.
Vel.Curve
Determines the dynamic response curve of the XTk's keyboard velocity. By selecting one of
the fix values, the dynamic velocity will be disabled and all notes are sent with the same
velocity. E.g. if you select fix100 , each note played on the keyboard will have a velocity of
100 .
R-Vel. C.
Same as Vel.Curve but determines the response of the keyboards release velocity. If off is
selected, the release velocity feature is disabled and a '90' message is sent for 'Note off'
instead of the '80' message that is sent if release velocity is enabled.
Prs. Curve
Determines the dynamic response of the XTk's keyboard aftertouch.
Pedal Type
Sets the polarity of the sustain pedal connected to the Pedal / CV In 1
not sure what type of pedal you have, try to use the closing option first. If the sustain
feature works in the opposite direction, i.e. notes are sustained without pressing the pedal,
try to use the opening setting.
Main Volume
Adjusts the master volume of all MicroWave II/XT/XTk's programs on both outputs. This
setting is also accessible from the Play page.
User's Manual MicroWave II • MicroWave XT • XTk
0...120
off / 1...16
exp2 / exp1 / lin / log1 / log2 / fix32...fix127
MIDI
Note
Velocity
127
log2 log1
lin
exp1 exp2
0
min
off / exp2 / exp1 / lin / log1 / log2 / fix32...fix127
exp2 / exp1 / lin / log1 / log2
closing / opening
0...127
Key Velocity
max
jack. If you are
95