Instrument Parameters; Selecting An Instrument For Editing; Sound - Waldorf MicroWave XT Bedienungsanleitung

Instrument parameters

The Instrument parameters consist of individual settings for each Instrument in a multi
program.

Selecting an instrument for editing

Before you apply any edits to an Instrument's parameter, you have to select the Instrument
to which the edits belong. Use the rightmost value dial
Instruments.
Instrument Select (e.g. 1)
The instrument no. is always displayed when a parameter page with Instrument relating
settings is selected. This is also valid when editing a sound program in Multi Mode because
the sound program belongs to an Instrument. The no. is not displayed while editing Multi or
Global parameters.
When editing an Instrument's Sound program, you can also switch among the Instruments
by turning the rightmost value dial

Sound

Sound 1
Sound 2
Sound 3
Bank
Selects the bank from which the sound program is taken.
Sound
Selects the instrument's sound program.
Channel
Determines the MIDI receive channel for the instrument.
• If omni is selected, the Instrument receives on all channels.
• If global is selected, the MIDI channel defined in the global parameters is used.
Volume
Determines the master volume for the instrument.
88
Bank | Sound
A | A001
when the Shift key
Bank | Sound
A | A001
Channel | Volume | Status
05 | 090
Panning | PanMod | Output
center | normal | Main Out
A / B
001...128
global / omni / 1...16
0...127
to switch between the
Saw Repeat WMF
is hold.
Saw Repeat WMF
| on
User's Manual MicroWave II • MicroWave XT • XTk
Inst. #1
Inst. #1
Inst. #1
Inst. #1