Inhaltsverzeichnis
Werbung
If you are in Multi mode, there is a corresponding function to init a Multi program.
You can select it by turning the page dial
Init Multi
5. Briefly press the Utility key
The selected program is now initialized.
When you initialize a program, all action takes place inside an edit buffer. Therefore
no data will be lost until you store the program.
Editing Parameters on the MicroWave XT
In addition to the sound editing capabilities of the MicroWave II/XT/XTk, the XT features
individual control elements for most parameters. This extended user interface offers you a
comfortable way of sound programming.
Dials
When turning a dial on the MicroWave XT panel, the corresponding sound parameter will
be changed. The parameter currently edited is shown in the upper right corner of the
display for a short period of time:
If the parameter is already shown in the display, only the value change will be displayed.
In the envelope section, you can select the active parameter set via the Env. Select button.
When holding the Shift key
contains the edited parameter. Instead of the Shift key
in the lower left of the panel.
Buttons
The MicroWave XT features three additional buttons: Sync, Glide and Env. Select.
• The Sync key enables or disables the synchronisation of oscillator 2. Its state is not
shown in the display but via a dedicated LED next to the key. Also, when holding
this key while turning a dial, the corresponding parameter page is called into the
display, as described above.
User's Manual MicroWave II • MicroWave XT • XTk
Init Multi 001
[confirm with <Shift-Utility>]
Play Sound A001
Saw Repeat
WMF |
while turning a dial, the display changes to the page that
one step clockwise again:
Hit Me Bigga WMF ?
while holding the Shift key
|
Mode
[Cutoff 059]
Sound
|
, you can also use the Sync key
again.
100
31
Werbung
Inhaltsverzeichnis
