Waldorf MicroWave XT Bedienungsanleitung Seite 84

abs value
min value
max value
lag proc.
filter
diff.
Parameter
Defines a value for modifier functions that require a constant parameter. See the Type
parameter described above for further details.
84
Returns the value of Source #1 without its sign. Negative values are
converted to their corresponding positive amounts. Parameter has no
function here. This function can be used e.g. for converting a bipolar
modulation source to a unipolar one, like opening the filter via Pitchbend
independent of the bending direction.
Returns the minimum value of either Source #1 or Parameter.
Returns the maximum value of either Source #1 or Parameter.
The lag processor creates a linear ramp from its current value, which is
initially minimum, to the value of Source #1. Then the ramp is stopped
until Source #1 changes again. The ramp time is specified by Parameter.
This function is useful when you want to apply a definable modulation over
a specified time, e.g. Modwheel controlled ramp for oszillator sweeps.
Level
Parameter
Performs a low pass filter function on Source #1. The filter frequency is
determined by Parameter's value. Use this function to smooth a signal.
Level
Performs a differential function on Source #1. The result of this function
represents the speed of value change in the selected source. Parameter has
no function here. This function is useful to detect if a source signal has
changed, e.g. the Modwheel was turned.
Level
0...127
Source #1
Lag processor function
Time
Source #1
Filter function
Time
Source #1
Differential function
Time
User's Manual MicroWave II • MicroWave XT • XTk