Switching Off The Drilling-Milling Machine; Traveling The Drilling Milling Head (Z-Axis) Upward Respectively Downward; Traveling The Drill-Mill Head Upward Respectively Downward By Actuating The Crank Handle - Optimum OPTImill BF 46TC Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
Also with a quick on and off, this overload occur. Therefore wait for about 3 seconds
before you switch on the drilling-milling machine again, the capacitors in the controller
must first discharged.
4.8

Switching off the drilling-milling machine


Press the push button "OFF". For a long-term standstill of the drilling-milling machine switch
it off at the main switch.
4.9

Traveling the drilling milling head (Z-axis) upward respectively downward

It is possible to perform the height adjustment of the drilling milling head by actuating the crank
handle or the control panel
4.9.1 Traveling the drill-mill head upward respectively downward by actuating the crank
handle
1 Crank handle
2 Clamping lever

Release clamping lever (2).

Engage the handle (1) by pushing it towards the teeth.

Crank the drilling milling head to the required position.

Clamp if needed.
GB BF46V | BF46TC
Page 86
Img.4-6: Drilling milling head - height adjustment
Img.4-7: Clamping lever
Original operating instructions
1
2
Version 1.1.3 dated 2014-4-8