Optimum OPTImill BF 46TC Betriebsanleitung Seite 98

OPTIMUM
M A S C H I N E N - G E R M A N Y
Interval Where?
First after 200
operatingm
hours, then
every 2000
operating hours
GB BF46V | BF46TC
Page 98
What? How?

For oil change use an appropriate collecting tray of suffi-
cient capacity.

Have the drilling-milling machine run for a few minutes, the
oil will heat up and will slightly penetrate from the opening.

Remove the ventilation screw from the gear.

Remove the oil drain plug.

Refill the oil over the removed ventilation screw.
Quantity and type of oil
Oil change
Ventilation screw of the gear
Original operating instructions

"Operating material" on page 69
Oil drain plug
Abb.5-3: Milling head
Version 1.1.3 dated 2014-4-8