Threading; Traveling The Drill-Mill Head Upward Respectively Downward Using The Control Panel; Inserting A Tool On Bf46Tc; Installation - Optimum OPTImill BF 46TC Betriebsanleitung

4.10

Threading


as described under

4.10.1 Traveling the drill-mill head upward respectively downward using the control panel

1
2
Img.4-8: Traveling the drilling milling head upward respectively downward using the control panel
1 Traveling the drilling milling head upward
2 Traveling the drilling milling head downward
3 End switch

Press the button (1) in order to travel the drilling milling head upward.

Press the button (2) in order to travel the drilling milling head downward.
The end switch (3) limits the vertical movement of the drilling milling head upward respectively
downward.
4.11

Inserting a tool on BF46TC

4.11.1 Installation

CAUTION!
When milling operations are performed the cone seat must always be fixed to the draw-
in rod. All cone connections with the taper bore of the work spindle without using the
draw-in rod is not allowed for milling operations. The cone connection should be
released by the lateral pressure. Injuries may be caused by parts flying off.
The milling head is equipped with a pneumatic tool changer and a M16 draw in bar.
Version 1.1.3 dated 2014-4-8
"Threading" on page 82
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
3
BF46V | BF46TC GB
Page 87