Unfitting - Optimum OPTImill BF 46TC Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y

Clean the seat in the spindle / quill.

Clean the taper of your tool.

Insert the tool in the spindle / quill.

Clamp the tool fixture by actuating the pressure switch "Clamping" on the control panel. The
fixture will be drawn into the spindle. Press the push button switch until the tool is securely
clamped.
ATTENTION!
Push button "CLAMPING"
Make sure that the tool seat is correctly positioned (ISO 40).
The tool clamping system must not be activated when the machine is operated.

4.11.2 Unfitting


Release the tool by actuating the switch "Release". The fixture comes out of the spindle.

Press the push button switch until the tool is completely detached.
Push button "RELEAS-
ING"
GB BF46V | BF46TC
Page 88
Img.4-10: Installation tool
Img.4-11: Extraction tool
Original operating instructions
Img.4-9: Installation tool
Version 1.1.3 dated 2014-4-8