Control Panel - Optimum OPTImill BF 46TC Betriebsanleitung

4.1.1 Control panel

21
22
23
26
Pos. Designation
20 Speed control
22 EMERGENCY-STOP
24 Push button spindle rotation "ON"
26 Main switch
3 Digital display fine crossfeed of spindle
sleeve
Selection switch for operating mode
With the selector switch the operating mode „automatic, threading or right-hand respectively
left-hand run" is being selected.
Operation mode automatic
In the automatic mode the engine starts up according to a predefined path over the drilling
depth limit of the spindle sleeve and stop at the end position. This way for, the push button Start
and Stop does not have to be actuated for repetitive drilling tasks.
Version 1.1.3 dated 2014-4-8
20
25 24
3
Img.4-2: Control panel
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
9
Pos. Designation
21 Digital display speed
23 Selection switch operating mode

Automatic

Threading

turning direction
25 Push button spindle rotation "OFF"
6 Selector switch for reduction stage
9 Fine adjustment of spindle sleeve
6
BF46V | BF46TC
Page 79
GB