Maintenance; Safety; Preparation; Restarting - Optimum OPTImill BF 46TC Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
5

Maintenance

In this chapter you will find important information about

Inspection

Maintenance

Repair
of the drilling-milling machine
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the drilling-milling machine and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

Very serious injury to personnel working on the,

Damage to the drilling-milling machine.
Only qualified staff should carry out maintenance and repair work on the drilling-milling
machine.

5.1.1 Preparation

WARNING!
Only carry out work on the drilling-milling machine if it has been disconnected from the
mains power supply.

"Disconnecting and securing the drilling-milling machine" on page 67
Attach a warning sign.

5.1.2 Restarting

Before restarting run a safety check.

"Safety check" on page 65
WARNING!
Before starting the drilling-milling machine, you must check that there is no danger for
persons and that the drilling-milling machine is not damaged.
GB BF46V | BF46TC
Page 96 Original operating instructions Version 1.1.3 dated 2014-4-8