Repair - Optimum OPTImill BF 46TC Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
Interval Where?
As required
INFORMATION
The spindle bearing is lifetime-lubricated. It is not necessary to lubricate it again.
5.3

Repair

Request for a service technician of the company Optimum Maschinen Germany GmbH for all
repairs.
If the repairs are carried out by qualified technical staff, they must follow the indications given in
these operating instructions.
The company Optimum Maschinen Germany GmbH does not take responsibility nor does it
guarantee for damages and failures resulting of non-observance of this operating manual.
For repairs only use

faultless and suitable tools

only original parts or parts from series expressly authorised by Optimum Maschinen Ger-
many GmbH.
GB BF46V | BF46TC
Page 100
What? How?
Regulating screw V-ledge
Readjusting
Regulating screw V-ledge
Z axis:

Proceed as described under "Readjusting X and Y axis".
Original operating instructions
Z-axis top
Z-axis bottom
Img.5-6: Column and mill head
Version 1.1.3 dated 2014-4-8