Protective Cover; Separating Protective Equipment; Safety Check - Optimum OPTImill BF 46TC Betriebsanleitung

WARNING!
Dangerous voltage even if the main switch is switched-off. In the areas marked by the
ideogram in the margin, there might be voltage, even if the main switch is switched off.

1.8.3 Protective cover

The drilling / milling head is equipped with
a protective cover.
WARNING!
Only remove the protective cover
when the mains plug of the drilling-
milling machine is disconnected.

1.8.4 Separating protective equipment

Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that the
cover is closed.
INFORMATION
You cannot start the machine if the spin-
dle protection is not closed.
1.9

Safety check

Check the drilling-milling machine in regular intervals.
Check all safety devices

before each operation,

once a week (with the machine in operation),

after every maintenance and repair work.
General check
Equipment
Protective covers
Signs,
Markings
Version 1.1.3 dated 2014-4-8
Protective
cover
Clamping screw
Check
Mounted, firmly bolted and not damaged
Installed and legible
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Img.1-4: Protective cover
Img.1-5: Separating protective equipment
BF46V | BF46TC
OK
GB
Page 65