Fuels, Coolants And Lubricants - Jungheinrich EFG 430 Betriebsanleitung

5.1

Fuels, coolants and lubricants

Handling consumption type material: Consumption type material must always be
handled properly. Manufacturer's instructions to be observed.
F
Improper handling is injurious to health, life, and environment. Consumption type ma-
terials must be stored in adequate containers. They might be inflammable and, there-
fore, must not come into contact with hot components or open fire.
When filling in consumption type materials use clean containers only. It is prohibited
to mix consumption type materials of different grades or qualitiies resp., except if mix-
ing is expressively prescribed in these operating instructions.
Avoid spilling. Spilt liquid must be removed immediately using a suitable binding
agent, and the mixture of consumption type material and binding agent is to be dis-
posed of according to the regulations.
Code Order-no.
50426072
50429647
A
50124051
51082888
D 50429647
E 50055726
G 29201280
N 50137755 2x approx. 3 l
F
The trucks are filled at the factory with H-LPD 32 hydraulic oil or Plantosyn 46 HVI
BIO hydraulic oil.
You cannot change from “"Plantosyn 46 HVI”" BIO hydraulic oil to H-LPD 32. The same
applies to changing from H-LPD 32 hydraulic oil to Plantosyn 46 HVI BIO hydraulic oil.
Furthermore you cannot mix H-LPD 32 hydraulic oil with Plantosyn 46 HVI BIO
hydraulic oil.
Grease data
Code Saponification Drop point
E Lithium
1)
valid for temperature -5/+30 °C
2)
valid for temperature -20/-5 °C
3)
valid for temperature +30/+50 °C
Quantity Designation
Renolin 32
Renolin 22
34.5 l 3)
HV 68
Plantosyn 46 HVI
(BIO hydraulic oil)
0.25 l Renolin 22
Lubricating grease
3)
KP 2 K
Chain spray
Shell Donax TC 50
Universal
Worked
°C
penetraton at
25 ° C
185 265-295
1)
HLPD
2)
HLPD Hydraulic system
Hydraulic brake system
Front and rear wheel -
wheel bearing
Chains
Transmission
NLG1 class
2
Used for
Usage
temperature °C
-35/+120
F 7