– Drive the truck with forks spread as far
apart as possible underneath the load.
F
At least two thirds of their length must
extend into the load.
– Apply the parking brake (3). Raise the
fork carriage until the load rests freely
on the forks.
– Set the travel direction switch (92) to
reverse and release the parking
brake.
F
Make sure you have enough space to
reverse into.
– Reverse carefully and slowly until the
load is outside the storage area.
F
xDo not stand underneath a raised load.
Do not reach through the mast.
– Tilt the mast fully backward:
– Lower the load as far as is absolutely
necessary
clearance approx. 150...200mm).
F
When transporting loads, the mast must
be tilted back and the forks lowered as
far as possible.
for
transport
(ground
103
3
E 37