Jungheinrich EFG 430 Betriebsanleitung Seite 60

3.5.1 Safety restraint system (automatic) operating instructions (o)
F
Test the restraint system before starting the truck.
The stop knob (97) must not be
engaged.
–– Sit down on the seat
–– Turn the key switch “"On”".
After releasing the parking brake the two
safety gates (LH and RH) close and lock
automatically.
Make sure the safety gates are free to
move.
After parking the truck and applying the
handbrake, the safety gates open
automatically.
The key switch should only be turned to “"0”" and removed when the safety gates have
been opened.
If the event of a power failure, the restraint system can be unlocked by pulling the
knob (98). The safety gates can be moved back manually.
Electronic Safety Restraint Sysetm (ERS with folding gate)
Electronic Safety Restraint System with automatic closing (ERS-AS with
folding gate)
When the truck is switched off and the handbrake applied the safety gates are folded
up. After powering up the truck (Emergency Disconnect, key switch) and releasing
the handbrake, the safety gates automatically close (horizontal position). When the
parking brake is applied the safety gates open automatically.
3.5.2 Safety restraint system (mechanical) operating instructions (o)
F
Test the restraint system before starting the truck.
To open, push the left hand restraint gate in and at the same time lift it up, when the
gate is released it automatically drops down and locks.
Mechanical restraint system with electronic control (HRS-E with folding gate)
To open, push the left safety gate in. The gate opens automatically through spring
pressure. To close, push the safety gate down. The closed gate is monitored by
switches.
Z
The truck will not travel with an open safety gate.
97
98
E 21