Fuels, Coolants And Lubricants - Jungheinrich EFG-DH ac 10 Betriebsanleitung

5.1

Fuels, coolants and lubricants

Handling consumption type material: Consumption type material must always be
handled properly. Manufacturer's instructions to be observed.
f
Improper handling is injurious to health, life, and environment. Consumption type ma-
terials must be stored in adequate containers. They might be inflammable and, there-
fore, must not come into contact with hot components or open fire.
When filling in consumption type materials use clean containers only. It is prohibited
to mix consumption type materials of different grades or qualitiies resp., except if mix-
ing is expressively prescribed in these operating instructions.
Avoid spilling. Spilt liquid must be removed immediately using a suitable binding
agent, and the mixture of consumption type material and binding agent is to be dis-
posed of according to the regulations.
Code Order-no.
5051148
A 044923
030901
D 002832
E 044168
G 045048
N 012451
Grease standard values
Code Type of Sa-
ponification
E Lithium
1)
valid at temperature -5/+30 °C
2)
valid at temperature -20/-5 °C
3)
valid at temperature +30/+50 °C
4)
Brake fluid DOT 4 should be favourably used.
Qty Designation
1)
H-LPD 32
2)
14.5 l H-LPD 22
3)
HV 68
Brake fluid
SAE J 1703
0.25
FMVSS 116
DOT 3 und DOT 4
Grease K-L 3N
Chain spray
4.15 l Gear oil EP 80
Drop point Walkpenetration
bei 25 °C
°C
185 265-295
Hydraulic system
4)
Hydraulic brake system
Front and rear wheel - wheel
3)
bearings
Chains
Transmission
NLG1-Class
2
Used for
Service-
temperature °C
-35/+120
F 7