Jungheinrich EFG 430 Betriebsanleitung Seite 86

Electr. 7.1 Check function of instruments and indicators
system:
7.2 Check cables for secure connection and damage
7.3 Check cable guides for function and damage
7.4 Check the warning devices and safety circuits for correct
7.5 Check contactor
7.6 Check fuses for correct amperage
7.7 Clean installation space of electronics and cooling fins
7.8 Read out and clear error memory
Electric 8.1 Check the motor for secure attachment
motors:
8.2 Check fan for correct function
8.3 Clean motor cooling fins
Battery: 9.1 Check battery cables for damage and replace, if
9.2 Check acid density, acid level, and cell voltage
9.3 Check terminals for secure attachment and apply
9.4 Clean battery plug connections, check for tight seat
Mast: 10.1 Apply grease to the tracks and the side contact surface of the
10.2 Check lift chains for wear and adjust.
10.3 Lubricate lift chains and check tension.
10.4 Check mast attachment
10.5 Check tilt cylinder suspension and attachment
10.6 Check forks and fork carriage for wear and damage
10.7 Visually inspect rollers, slide pieces and stops
10.8
10.9
General 11.1 Test electrical system for frame leakage in accordance with
Measurements:
11.2 Test travel speed and braking distance
11.3 Test lift and lowering speeds
Demonstration 12.1 Test run with rated load
12.2 After carrying out maintenance, present the truck to the
function
necessary
grease
guide rollers in the mast sections.
Test mast tilt angle.
Make sure both tilt cylinders extend evenly.
Check mast play and if necessary adjust lateral play using
spacers.
VDI 2511
supervisor.
Maintenance intervals
t
Standard = W A B C
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
F 5