Closing Battery Cover; Battery Discharge Indicator, Exhaustive Discharge Protection Device, Operating Hour Meter - Jungheinrich EFG 430 Betriebsanleitung

7

Closing battery cover

With MULTI PILOT or multifunction
steering wheel::
–– Pull control valve cover forward and
simultaneously unlatch it by pressing
lever (8). Control valve cover moves
back by itself.
With SOLOPILOT:
–– After closing the battery cover, swivel
control valve cover to the back until it
engages.
8 Battery discharge indicator, exhaustive discharge protection device, operating
hour meter
Battery discharge indicator: The charging condition of the battery is indicated on
the information and service display.
M
The standard setting of the battery discharge indicator / discharge monitor is made
using standard batteries.
When using maintenance-free batteries, the display must be readjusted. The setting
must be performed by customer service engineers. If this setting is not performed, the
battery might suffer damage caused by exhaustive discharge.
When reaching the last 10 % of the available capacity, the warning symbol flashes.
When a battery is discharged to the permissible discharge level, the battery symbol
is displayed empty.
Battery discharge monitor: As soon as the capacity falls below the residual battery
capacity, the lifting function will be switched off. This is indicated by a message dis-
played on the information and service display.
In order to complete the lifting process, the key switch must be switched off and on
again, which enables lifting for another 30 to 40 seconds.
Z
Lifting will only become possible again after the battery has been recharged to at least
40 %.
Operating hour meter: The operating hours are indicated next to the charging state
of the battery. The service hours are counted when the truck is switched on and the
seat switch is closed.
D 8
8