Closing Battery Cover; Battery Discharge Indicator, Exhaustive Discharge Protection Device, Operating Hour Meter - Jungheinrich EFG-Vac 25 Betriebsanleitung

7

Closing battery cover

With MULTIPILOT:
–– Pull control valve cover forward and
simultaneously unlatch it by pressing
lever (8). Control valve cover moves
back by itself.
With SOLOPILOT:
–– After closing the battery cover, swivel
control valve cover to the back until it
engages.
8 Battery discharge indicator, exhaustive discharge protection device, operating
hour meter
Battery discharge indicator: The charging condition of the battery is indicated in
10% increments on the information and service display (100% = battery capacity
100%, display 0% = battery capacity 20%).
m
The standard setting of the battery discharge indicator / discharge monitor is made
using standard batteries.
When using maintenance-free batteries, the display must be readjusted. The setting
must be performed by customer service engineers. If this setting is not performed, the
battery might suffer damage caused by exhaustive discharge.
When reaching the last 10% of the available capacity, the warning symbol flashes.
Recharging is required at a remaining battery capacity of 20% for standard batteries
and 40% for maintenance-free batteries.
Battery discharge monitor: As soon as the capacity falls below the residual battery
capacity, the lifting function will be switched off. This is indicated by a message
displayed on the information and service display.
In order to complete the lifting process, the key switch must be switched off and on
again, which enables lifting for another 30 to 40 seconds.
A
Lifting will only become possible again after the battery has been recharged to at least
40%.
Operating hour meter: The operating hours are indicated next to the charging state
of the battery. The operating hour meter shows the total time of the travelling and
lifting movements.
8
D 7