Important Safeguards For Electrical Appliances - Gastroback Design Brotbackautomat Plus Bedienungsanleitung

for moving the appliance. Do not place any hard and/or heavy objects on or in
the appliance or any part of it.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or
any corrosive chemicals (e.g. bleach) for cleaning. This is especially because small
parts of scouring pads could get into the appliance, causing hazard and damage
due to overheating, fire and electric shock.
• Do not place the appliance or any part of the appliance or the power
cord in an automatic dishwasher.
• Do not leave any food dry on the appliance. Always clean the appliance after
each use to prevent an accumulation of baked-on foods (see ›Care and Cleaning‹).
Always keep the appliance and its parts, where it is clean.

ImPortant saFeGuarDs For electrIcal aPPlIances

The appliance is heated electrically. Place the appliance near a suitable wall power
socket to connect the appliance directly to a protected mains power supply with
protective conductor (earth/ground) connected properly. Ensure that the voltage
rating of your mains power supply corresponds to the voltage requirements of the
appliance (230-240 V, 50 Hz, AC, rated for at least 8 A) to avoid interference with
other appliances.
The installation of a residual current operated circuit breaker (r.c.c.b.) with a maxi-
mum rated residual operating current of 30 mA in the supplying electrical circuit is
strongly recommended. If in doubt, contact your electrician for further information.
In various foreign countries, the specifications for power supplies are subject to
incompatible norms. Therefore it is possible that power supplies in foreign countries
do not meet the requirements for safe operation of the appliance. Thus, before ope-
rating the appliance abroad, ensure that safe operation is possible.
• Do not use any desk top multi socket outlet, external timer, or remote control sys-
tems. It is best to avoid using an extension cord, but if you wish to use one, only use
an extension cord rated for a maximum continuous current of at least 8 A with safe-
ty plug and safety coupler plug and protective conductor (earth/ground) connected
properly. Additionally, the extension cord must be of sufficient length.
Always ensure that no one will step on power cords or gets entangled or trip over
power cords. Also, ensure that no tension is applied to any part of the power cords.
Tie the extension cord loosely onto the leg of the table using a separate cord, to
ensure that no one will pull the power cord. To connect: always connect the appli-
ance to the extension cord first. To disconnect: Always unplug the extension cord
from the power supply first.
• Always handle power cords with care. The pins of the power plug must be smooth
48