Care And Cleaning; Disassembling The Appliance - Gastroback Design Brotbackautomat Plus Bedienungsanleitung

Problem
L:LL (after starting the
program)
E:E0 (after starting the
program)
E:E1

care anD cleanInG

WarnInG – RISK OF BURNS
always ensure that the appliance is out of reach of young children.
Always switch OFF the appliance (START/STOP button), then unplug the appliance,
and wait until the appliance cooled down (up to 40 minutes), before moving or clea-
ning the appliance. Do not attempt to move the appliance during operation.
The surfaces of the bread pan and kneading paddle have a non-stick coating. Do
not scratch or cut on the non-stick coatings. Do not use any abrasive cleaners or cor-
rosive chemicals (e.g. bleach) for cleaning the appliance or any parts of it, to avoid
damage to the surfaces. Do not use any hard or sharp-edged objects for cleaning
any surfaces of the appliance. Additionally, particles derived from scoring pads
could get into the interior of the appliance, causing hazard due to overheating, fire
and/or electric shock.
Ensure to protect the appliance against splashing water and moisture. Do not
immerse the appliance, or power cord in water or any other liquid, to avoid hazards
due to electric shock and damage. Do not spill or drip any liquids on or in these
parts to avoid risk of fire and electric shock.
part of it in an automatic dishwasher.

DIsassemBlInG the aPPlIance

1. Switch OFF the appliance by pressing the START/STOP button for approx. 2
seconds. Then unplug and leave the appliance cool down to room temperature
(at least 40 minutes).
2. Take the bread pan out of the heating compartment. For this, turn the bread pan
counterclockwise until you can easily lift it out of the heating compartment.
3. Take the kneading paddle out of the bread pan. If the kneading paddle sticks to
the drive shaft and is hard to remove, fill the bread pan with hot dishwater for
approx. 30 minutes. Then try again.
Possible Reason
The temperature is too low.
The temperature probe failed.
The temperature probe failed.
The Solution
The ambient temperature should not be be-low 15°C.
Send the appliance to an authorized service centre for
repair.
Send the appliance to an authorized service centre for
repair.
Do not clean the appliance or any
Do not use violence!
67