Gastroback Design Brotbackautomat Plus Bedienungsanleitung Seite 52

Button Function
STOP For termination of a program, keep the button pressed until a signal
sounds.
note:
deleted. There is no way to continue the previously used program. Thus,
do NOT use this button, if you wish to add further ingredients. In this
case, unplug the appliance for no longer than 10 minutes.
COLOR Use for selecting the desired colour of your bread: Light, Medium, or
Dark.
Your choice is indicated via an arrow on the left side of the LCD screen.
For the programs 8, 9, 10, and 13 this button is ineffective.
LOAF Use for setting the total amount of ingredients. Your choice is indica-
ted via an arrow on the right side of the LCD screen. Use the following
settings:
• Large – for a total amount of all ingredients between 500 g and
750 g.
• Small – for a total amount of all ingredients up to 500 g.
When selecting Small for more than 500 g, your bread may not
tIP:
be done completely. In this case, you can use the program BAKE for
additional baking.
For the programs 7 to 13 this button is ineffective.
T I M E + Use these buttons to set up the Timer in steps of 10 minutes.
und
Minimum: processing time of the currently selected program. Maximum:
TIME–
13 hours.
tip: With your finger kept on the button, after a short delay the time
setting will run automatically until you remove your finger.
note:
tons to adjust the processing time.
For the programs 6, 7, 10, and 11 these buttons are ineffective.
Friendly note:
The bread maker is in data initiation mode during the first 3 seconds, after it has
been plugged in. Please do not press any buttons during this time. If you experience
any problems while using the control buttons, unplug the bread maker from the
mains outlet and plug it in again. The control buttons should work properly again.
52
After terminating a program with this button, all settings are
With the programs BAKE or YOGHURT selected, use these but-