Cleaning The Appliance; Reassembling The Appliance - Gastroback Design Brotbackautomat Plus Bedienungsanleitung

cleanInG the aPPlIance

Do not immerse the appliance, power cord or bread pan in water or
ImPortant:
other liquids to avoid damage.
an automatic dishwasher
thinners for cleaning the Bread Maker.
1. Clean the heating compartment and lid using a wet cloth or a slightly wet soft
sponge. Ensure that no fluffs or other particles remain on the heating elements.
2. Wipe the exterior of the appliance and power cord with a soft damp cloth. The-
reafter, polish with a dry cloth.
Do not immerse the bread pan in water or other liquids to avoid
ImPortant:
damage.
3. Clean all surfaces of the bread pan and the kneading paddle with warm dish-
water.
If the opening in the bottom of the kneading paddle is clogged, you should
soak the kneading paddle for some minutes in hot dishwater. Thereafter clean it
carefully using a small bottle brush. Do not use any chemical cleaning agents or
thinners to clean the bread maker.
4. Dry all parts thoroughly. Thereafter leave all parts dry naturally for at least 1
hour, where they are out of reach of young children.
5. Reassemble the appliance after cleaning as described below.

reassemBlInG the aPPlIance

It is good advice to reassemble the appliance after cleaning. This way, you avoid
damage to the parts of the appliance and the parts cannot get lost.
ImPortant: Before reassembling the appliance, always ensure that the parts of
the appliance are clean and completely dry. This is crucial especially for the heating
compartment and exterior of the bread pan. Otherwise, moisture could get onto the
heating elements and cause risk of overheating and electric shock.
1. Insert the kneading paddle into the bread pan.
2. Insert the bread pan into the heating compartment.
For this, put the bread pan into the centre of the heating compartment. Then turn
the bread pan until it settles down on the coupling of the kneading works. Turn
the bread pan clockwise until it locks on the coupling
3. Reassemble the lid: Insert the tappets on the hinges of the lid into the respective
openings at the upper side of the housing. Then press the lid down. When clo-
sing the lid, there may be no slit between lid and housing.
68
Do not clean the appliance or any part of it in
to avoid damage. Do not use any chemical agents or