Olympus WS-110 Bedienungsanleitung Seite 3

Recording (Fig. ])
1. Press the 2 (FOLDER) button to choose a folder.
2. Press the 4 button to start recording.
The record/play indicator light turns red, and recording starts.
• If you start recording after inserting the earphone into the
earphone jack on the recorder, you can hear the sound being
recorded. The sound volume on the recording monitor can be
adjusted by pressing the VOL (+) or VOL (–) button.
3. Press the 5 button to stop recording.
New recordings are saved as the last file in the folder.
` Current folder
1 Current recording mode 4 Remaining recording time (Remain)
2 Current file number
To Pause Recording (Fig. |)
Press the 4.
To Pause
Press the 4.
To Resume
Recording
Recording from External Microphone or
Other Devices (Fig. {)
The external microphone and other devices can be connected and
the sound can be recorded.
• To connect the recorder to an external device, use the optional
connecting cord KA333, and the stereo/monaural converting plug
adapter supplied with KA333.
• When the external microphone is connected to the microphone jack of
the recorder, the built-in microphone will not operate.
• When connecting an external microphone or other external equipment
to the microphone jack, choose adequate equipment, such as a mono
microphone (optional).
` To audio input terminal of other devices
1 Converting plug adapter of KA333
Notes
• If "Folder FULL" or "Memory FULL" appears on the display, you cannot
record. In such a case, erase unnecessary files or download to PC.
• If the recorder is placed directly on a table when recording a meeting,
it tends to pick up table vibrations. Put a notebook or other item
between the table and the recorder for clearer recording.
• Even if you press the 2 (DISP.) button, the display will not change to cur-
rent recording time if the remaining recording time is 1 minute or less.
• A beep will sound when remaining recording time reaches 60 seconds,
30 seconds, and 10 seconds while recording.
• When remaining recording time is less than 60 seconds, the record/
play indicator light starts flashing in red. When the recording time is
decreasing to 30 or 10 seconds, the light flashes faster.
• The recorder will enter Stop mode if it has been left paused for
60 minutes or longer.
• In case of difficult acoustic conditions or low speaker's voice, recording
in Stereo XQ, Stereo HQ, Stereo SP or HQ is recommended. Also, usage
of an external microphone (sold separately) could improve the quality of
recordings.
• The input level cannot be adjusted on this recorder. When you connect
the recorder to an external device, execute a test recording and adjust
the output level of the external device.
Playing Back
Playing (Fig. })
1. Press the 2 (FOLDER) button to choose a folder.
2. Press the 9 or 0 button to choose the file,
t
and press button.
The record/play indicator light turns green, and the elapsed
playing time is indicated on the display.
3 Recording time
5 Record level meter
"Rec Pause" appears on the display.
Recording will resume at the
point of interruption.
3. Press the + or – button to select the proper sound volume.
The display shows the volume level.
You can choose between 0 to 30.
` Current file number
Canceling Playback
Press the 5.
To Stop
t
To Resume Press the
Playback
Forwarding and Rewinding
Press and hold 9 or
0 during playback.
• The recorder pauses when it reaches to the end of the file during fast
forwarding or fast rewinding. Pressing and holding it continues fast-
forwarding or fast-rewinding.
• If there is an index mark or temp mark in the middle of the file, the
recorder will stop at that location.
Locating the Beginning of the File
Press the 9
Playback,
or 0 button.
Fast playback,
Slow playback
If there is an index mark or temp mark in the middle of the file,
the recorder will stop at that location.
Listening with Earphones (Fig. ≠)
You can listen to files by connecting earphones to the earphone jack.
If an earphone is connected, the speaker doesn't emit sound.
When connecting stereo earphones, the playback will be in stereo.
(Only when playing back stereo files.)
• To avoid irritation to the ear, insert the earphone after turning down
the volume level.
• When you listen with the earphones during playback, do not raise the
volume too much. It may cause hearing impairment and decrease in
hearing ability.
Erase
Erasing
You can easily erase unnecessary files. Sequential file numbers
are reassigned automatically.
Erasing One File at a Time (Fig.
` File to be erased
1. Press the 2 (FOLDER) button to choose a folder.
2. Press the 9 or 0 to select the file to delete,
and press 1 (ERASE) button.
" Cancel" and "Erase
3. Press the 9 button.
The "1File Erase?" indicator flashes.
t
4. Press the button.
The deletion is completed when "File Erase!" flash and
"Erase DONE" is displayed.
Erase All Files from a Folder (Fig.
` Folder to be erased
1. Press the 2 (FOLDER) button to choose a folder.
2. Press the 1 (ERASE) button twice.
" Cancel" and "Erase
1 Playing time
The recorder stops in the middle of
the file being played.
. Playback will resume at the
point of interruption.
When you release the button, the re-
corder will resume normal playback.
Jumps to the beginning
of the next file or the file
being played back.
«
)
" flashes alternately.
∑
)
" flashes alternately.
EN 7