Connecting./.Disconnecting.duofern.transmitters; Connecting./.Disconnecting.a.duofern.transmitter.with.the.help.of.a.set.button - RADEMACHER RolloTube I-line Funk Small Montageanleitung

Connecting / disconnecting DuoFern transmitters
Every.DuoFern.transmitter.that.is.required.for.operation.has.to.be.assigned.to.the.tubular.
motor.in.order.that.the.radio.tubular.motor.can.be.controlled.with.a.DuoFern.transmitter..
You.can.assign.a.maximum.of.20.DuoFern.transmitters,.e.g..DuoFern.manual.central.
operating.unit;..DuoFern.standard.manual.transmitter.etc..to.the.radio.tubular.motor..
Connecting / disconnecting a DuoFern transmitter with the help of a set button
1.
or
2.
3.
4.
5.
6. Points 1 to 4.
Symbols and actions when connecting a cord circuit setting unit (22)
or
when connecting an external switch.
Switch on the mains power.
ON
Activate connect / disconnect mode on the radio tubular motor by briefly pressing the set button (11).
The radio tubular motor is briefly running up and down and the motor set button (11) lights up orange by way
of acknowledgement.
(11)
Set.button. .with.LED
Subsequently activate connect / disconnect mode on the desired DuoFern transmitter. In order to do so, please
refer to the operating manual for the corresponding DuoFern transmitter.
In addition, please observe the remaining time window in which you are able to connect or disconnect the DuoFern
transmitter to/from the radio tubular motor.
The radio tubular motor acknowledges successful connection / disconnection by starting up briefly and the set
button LED turns green.
NOTE
The status LED lights up red if the connect / disconnect process fails, for example if :
. ◆ 20.DuoFern.transmitters.have.already.been.registered.
. ◆ an.unsuitable.device.(e.g..other.DuoFern.actuator).is.registered.
. ◆ an.attempt.is.made.to.log-off.a.DuoFern.transmitter.that.is.not.logged-on.
If necessary, you can subsequently connect / disconnect the next DuoFern transmitter. In order to do so, repeat
points 1 to 4.
There are various ways to connect the DuoFern transmitter to the
radio tubular motor or to disconnect the radio tubular motor:
1.. Connect./.disconnect.a.DuoFern.transmitter.with.the.help.of.a.set.button.on.the.
. tubular.motor.
2.. Connect./.disconnect.a.DuoFern.transmitter.with.the.help.of.the.radio.code.
3.. Remotely.log.on./.log.off.a.DuoFern.transmitter.with.the.help.of.the.DuoFern.central.
. operating. unit. (please. refer. to. the. DuoFern. central. operating. unit's. operating. .
. manual).
EN
53