Display; Calibrate - PeakTech 1295 Bedienungsanleitung

2. Select Time Config in the bottom menu; the Time Setting dialog will pop
up.
3. Touch the value that needs to be changed, a cursor will appear. You can
drag to select the numbers. Turn the G knob to change the selected
value. Touch OK to complete the setting.
To enable/disable VGA output
The VGA port could be connected to a computer monitor. The image of the
oscilloscope can be clearly displayed on the monitor.
3. Press the Utility button, select Config in the left menu.
4. Select VGA as ON or OFF in the bottom menu.
● Display
Press the Utility button and select Display in the left menu.
The description of
Display Menu
Function
Menu
BackLight
Graticule
Menu Display
Gesture
● Calibrate
Press the Utility button and select Calibrate in the left menu.
The description of Calibrate Menu is shown as the follows:
Function Menu
Self Calibrate
Factory Set
Touch Screen

Calibrate

Do Self-Calibration
The self-calibration procedure can improve the accuracy of the oscilloscope
under the ambient temperature to the greatest extent. If the change of the
ambient temperature is up to or exceeds 5℃, the self-calibration procedure
is shown as the follows:
Setting Description
Drag the slider or turn the G knob to
0%~99%
adjust the backlight.
Select the grid type
Set the disappear time of left and right
5s~50s, Infinite
menu
ON, OFF Enable/disable the touchscreen controls
Description
Carry out the self-calibration procedure.
Call out the factory settings.
Touchscreen accuracy calibration
135