Safety; Safety Instructions; Hazards If The Safety Instructions Are Not Complied With; Unauthorized Alteration And Spare Part Fabrication - Kemper KHS-Mini MASTER Einbau- Und Bedienungsanleitung

3.

Safety

The descriptions and instructions in
these operating instructions concern
the KHS Mini
-MASTER- and KHS
Control -SLAVE-.
3.1

Safety Instructions

Before commissioning, make sure the connections have been made properly and
professionally and that the system is properly protected. Comply with the pertinent
regulations (EN, VDE, etc.) and the regulations of the local energy utility.
3.2

Hazards if the safety instructions are not complied with

Non-compliance with the safety instructions can result in both hazards to people and
hazards to the environment and the system. Non-compliance with the safety instructions
leads to the loss of rights to any compensation claims. In some cases, non-compliance
can, for example, result in the following hazards:
Failure of important functions in the device
Hazards to people through electrical and mechanical effects
3.3

Unauthorized alteration and spare part fabrication

Alternations and modifications to the device are only permissible after agreement with
the manufacturer. Original spare parts and manufacturer authorised accessories serve
the purpose of safety. The use of any other parts may annul the liability for any resultant
consequences.
Attention:
Use only original/approved spare parts
will be recognized.
3.4

Unauthorised modes of operation

The reliability of the supplied unit is only ensured when used as intended. Never exceed
the limits stated in this documentation under any circumstances.
Note:
If the operating instructions are not followed, the manufacturer of this
controller does not assume any responsibility. These operating
instructions contain basic instructions that must be complied with
during
plumber/mechanic and the responsible specialists/operators must read
these operating instructions before assembly and commissioning.
Comply not only with the general safety instructions listed in this main
point; also follow the specific safety instructions listed under the other
main points.
Manual KHS Mini System Control MASTER
System Control
Mini System
set-up, commissioning
Warning notice:
During assembly
maintenance, make sure that
the control is not switched on.
Only skilled
personnel are
operate electrical systems (as
per DIN EN 50110-1). Danger
of fatal electric shock.
otherwise no warranty claims
and maintenance.
3
and
professional
permitted to
Therefore, the