TEFAL Clipso +Chef Bedienungsanleitung Seite 48

Changing the timer battery
• Battery life depends on how often the timer is used.
However, when you notice a total or partial loss of the
display, you will need to change the battery.
• To help protect the environment, remove the used battery.
Do not dispose of it with household waste, but take it
to a specialised collection centre. The timer battery is a
lithium manganese button cell. It complies with European
regulations.
• You can replace the battery in the timer, reference CR2032,
or have it replaced by a retailer approved for this type of
service.
• To remove the battery from your timer,
battery cap with a coin by turning it anticlockwise so that
the 1/2 moon ◗ on the cap lines up with the 1/2 moon on
the timer ◗ (see drawing opposite).
• Replace your battery.
• Reposition the seal in its housing.
• To reposition the battery cap, position the 1/2 moon ◗
of the battery cap opposite the 1/2 moon ◗ of the timer.
Gently turn the battery cap clockwise, whilst applying light
pressure to align the 1/2 moon ◗ of the battery cap with
the full moon of the timer ● (see the opposite diagram).
• Close the battery cap gently; do not force it beyond the
stops. Fig. 11,
Recommendations for use:
• Do not force the battery cap when closing it.
• Should you misplace your timer, another can be purchased
from any of our Tefal Approved Service Centres.
To store the Clipso +Chef
®
• Return the lid to the pan.
90
Fig. 11, open the
SAFETY
Clipso +Chef is equipped with several safety devices.
®
Safe closing
• If the lid is not properly closed, no cooking programme can be selected and the
Clipso +Chef cannot be pressurised.
®
Safe opening
• If Clipso +Chef is pressurised, the opening/closing handle cannot be operated
®
because the mechanism is locked by the pressure indicator.
• In this case, don't try to force it open, but turn the selector to
pressure indicator (D) to drop before opening the Clipso
Overpressure protection
• Clipso +Chef is equipped with two overpressure safety devices:
®
- First device: the safety valve (M) releases the pressure and steam escapes under
the control module: Fig. 19.
- Second device: the seal (H) allows steam to escape between the lid and the
pan. Fig. 20.
• If one of the over-pressurisation safety systems is triggered:
- Turn o the heat.
- Allow the Clipso +Chef to cool completely.
®
- Open it.
- Check and clean the operating valve (L), steam release outlet (A),
safety valve (M) and seal (H).
CHARACTERISTICS
Compatible heat sources
GLASS-CERAMIC
GAS ELECTRIC HOB
and wait for the
+Chef.
®
HALOGEN
RADIANT INDUCTION SPIRAL ELECTRICITY
EN
91