Werbung
Verfügbare Sprachen
Verfügbare Sprachen
VC-A30G(BR) VC-A30S(BR)
VC-A30GM(BR) VC-A30SM(BR}
VC-A300M(BR) VC-A30SV(BR)
REPLACEMENT OF LOCK RELEASE LEVER
@ Removal
1. Place the slider in the cassette down position.
(Turn the coupling on the worm shaft clockwise
until the slider is in the cassette down position.)
Note: Before shifting, unlock the slider.
2. Slightly widen the cassette housing frames (R)
and (L) to unhook the slider holders (R) and (L) of
the slider assembly off the grooves of the
cassette housing frames.
Pulley
Cassette housing
frame
(R)
To be
widened.
0 \
Cassette housing
' frame (L)
=
~
re
AT
=)
'
' To be widened.
Slider holder
;
(R)
Stider holder (L)
Slider
(b)
Figure 1-17.
3. Lift the slider holder (R) upward about 2mm off
the slider by pressing two catches with a thin tip
screw driver.
Take care not to damage the
catches.
Slide lock catch
Siide tt upward
about
2 mm.
Catch
oo?
'
{
i
Opening (an
t
Lock release lever spring
Catch%
Press here.
Figure 1-18.
15
4. Remove the lock release lever from the slider
holder (R)
@ Reassembly
1. Follow the steps for removal in the reverse order.
(See Figures 1-17 and 1-18.)
2. Attach the lock release lever to the slider
holder (R).
3. Slide the slider holder (R) downward so that the
two catches of the slider holder (R) fit the
opening of the slider.
4. Slightly widen the cassette housing frames, and
set the pins of slider holders (R) and (L) into the
grooves of the cassette housing frames.
Note: Check if the pins of the slider holders (R)
and (L) fit the grooves of the cassette
housing frames, and if the drive gear arm
is sufficiently engaged with the slider
holders.
5. Turn the coupling counterclockwise
until the
slider is at the cassette insertion opening.
TO RUN A TAPE WITHOUT THE CASSETTE
HOUSING CONTROL ASSEMBLY
. Plug in the power cord.
. Turn on the power switch.
. Open the lid @ of a cassette tape by hand.
. Hold the lid with a piece of vinyl tape @.
. Set te cassette tape in the mechanism chassis.
. Weight the cassette tape with a weight @ to
prevent floating.
7. Perform running test.
AmnhWwn—
Weight to prevent (a)
float (500 g)
Note:
The weight should not be more than 500 g.
Figure 1-19.
Werbung
