Werbung
Verfügbare Sprachen
Verfügbare Sprachen
B tight screw
VC-A30G(BR) VC-A30S(BR)
VC-A30GM(BR) VC-A30SMIBR)
VC-A30QM(iBR) VC-A30SV(BR)
5. Tighten one B tight screw.
analy
resin-mode boss can be broken.
6. Place the start sensor
PWB
on the cassette
housing frame (R).
>
Note: Check that the switch connectors (No. 16,
Tally mark j
17) are in the cassette switch mounting
C)
>
.
hole.
cut washer
Tally mark
Worm wheel
7. Finally resolder the cassette switch connector to
the start sensor PWB.
REASSEMBLY OF DRIVE GEAR
(a)
(b)
Figure 1-9.
3. Install the pulley and the cassette loading belt on
Drive gear arm
the worm shaft assembly.
Couple the clutch to
Or've gear spring (R)
the clutch lever.
And mount them together in
()
the cassette housing frame (R).
=
__Wec
Note: Keep in mind that the clutch switching
lever should be in the correct position.
The mechanism might
malfunction if the
lever is slightly out of position. (See page
Reciprocating
sprin
14.)
ore
(a)
Cassette loading beit
Cassette
Drive gear
~ housin
spring (R}
Drive gear
\
9g
spring
(R)
"
)
frame
(R)
Worm
}
a
shaft bearing
Drive gear arm
wheel
}
iy)
Figure 1-10.
. Attach the worm
bracket to the worm shaft
ae
etn
assembly.
Place them onto the boss on the
cassette housing frame (R).
Bente ae
(Drive gear bottom view)
Note: Insert © before screwing into @ and ©.
seiitig. 18
Drive gear arm
(b)
Figure 1-12.
Cassette housing frame (R)
1. Pass the tip of the drive gear spring (R) ©
through the square hole of the drive gear (R) to
Switch lever
hook the spring in position.
2. Hook one end © of the reciprocating spring to
the catch of the drive gear (R).
3. Hook the other end @ of the reciprocating
|
spring to the catch of the worm wheel.
I (3) Cassette housing frame (R) boss
4. Insert the pillar @
of the drive gear (R) into the
|
square hole of the worm wheel. Turn the worm
wheel somewhat counterclockwise for insertion
of the worm wheel to the drive gear (R), because
the reciprocating spring is at work.
Worm
bracket
cy
Figure 1-11.
13
Werbung
