Siemens SIMOVERT MASTERDRIVES Motion Control Betriebsanleitung Seite 130

First Start-up
Parameterizing by
download or with
parameter modules
Function test
Further start-up and parameterization according to
3-2
AAA
After checking the unit and the cabling once more,
power up the line voltage or DC bus voltage, if you have
not already done so, and perform a function test
according to your parameterization.
WARNING It must be ensured that no danger for
persons and equipment can occur by
energizing the power and the unit. It is
recommended not to couple the driven
machine until the function test has
been successfully completed.
your specific requirements
6SE7087-6JD50
Operating Instructions SIMOVERT MASTERDRIVES
01.2000
See section
"Parameterization"
siehe
"Anschließen"
und "EMV-
gerechter
Aufbau"
siehe "Ans
Siemens AG