Inhaltsverzeichnis
Werbung
IQT3-FP-IO-V1
Zertifikate und Zulassungen
2
Zertifikate und Zulassungen
2.1
Konformitätserklärung (RE Directive 2014/53/EU)
Dieses Produkt wurde unter Beachtung geltender europäischer Normen und Richtlinien ent-
wickelt und gefertigt.
Hinweis!
Eine Konformitätserklärung kann beim Hersteller angefordert oder im Internet unter
www.pepperl-fuchs.com heruntergeladen werden.
Der Hersteller des Produkts, die Pepperl+Fuchs SE in 68307 Mannheim, besitzt ein zertifizier-
tes Qualitätssicherungssystem gemäß ISO 9001.
ISO9001
2.2
FCC-Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation.
Attention:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Hinweis!
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
FCC Notice
To comply with FCC part 15 rules in the United States, the system must be professionally instal-
led to ensure compliance with the Part 15 certification. It is the responsibility of the operator
and professional installer to ensure that only certified systems are deployed in the United Sta-
tes. The use of the system in any other combination (such as co-located antennas transmitting
the same information) is expressly forbidden.
FCC Exposure Information
To comply with FCC RF exposure compliance requirements, the antennas used for this trans-
mitter must be installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operated in conjunction with any other antenna or transmitter.
9
Werbung
Inhaltsverzeichnis
