Staff Code Entry; Standard Tapping Display - ECOLAB DG 3.1 Betriebsanleitung

9.3

Staff Code Entry

Once the STAFF CODE function is activated in programming
mode, you have to enter a two-digit staff code using the control
panel. Thereafter, the device is released for disinfectant
tapping.
You enter the staff code as follows:
 Set assigned staff code by means of
 Press the
The standard tapping display appears.
Following each tapping process, the message STAFF CODE 00 appears on the display
screen again.
If an incorrect staff code is entered, the display turns red for 2 seconds.
You then have to enter the staff code correctly.
9.4 Tapping Quantity Entry (Tapping quantity selection)
The last withdrawal quantity (tap quantity) selected is always displayed on the screen for
the next tapping process for information purposes. If required, you can change the tapping
quantity in steps between 0.5 l and 99 l for the new tapping process.
If the "Selective Tapping Quantity Selection" function has been
set in programming mode, you can only select predefined
values (maximum of five).
The required tapping quantity can be set by pressing the
or buttons.
The entered value is displayed on the screen
(in the example, the tapping quantity is 5 l).
9.5 Switch from concentration 1 to concentration 2
Initially, the display screen always displays the value set for concentration 1:
You can choose between concentration 1 and concentration 2 by means of
The concentration which is currently active appears on the display screen.
You can only ever switch to concentration 2 for one tapping process. Once that tapping
process is complete, the metering unit automatically switches back to concentration 1.
NOTE
The values for concentrations 1 and 2 can only be set and changed in programming mode.
417102242_DG_3
button to confirm the entry.
- 87 -
Staff code activated:
Fig. 9.3
, , , .
Fig. 9.4
Example:
Fig. 9.5
Staff code entry

Standard tapping display

Standard tapping display
or .
Rev.: 02-05.2014