Residual Quality Display - ECOLAB DG 3.1 Betriebsanleitung

9.6 Tapping the Ready-to-Use Disinfectant Solution
You tap the ready-to-use solution by pressing the
During the tapping process, the remaining quantity is counted
down on the display screen.
Once the specified tap quantity has been extracted, the
metering unit automatically switches off.
You can cancel the tapping process early whenever you want by pressing
(for example, if you accidentally choose a receptacle that is too small). Note that the entire
selected quantity will be extracted again once you restart the tapping process.
The remaining quantity of an interrupted tapping process is not taken into account for the
new tapping process.
9.7 Switching to a New Product
ATTENTION
You proceed as follows to switch to a new product:
 Fill a suitable container with water and connect suction lance to container in question.
 Undo the swivel nut at the admission point, remove the flow monitor
(see chapter 5.1, Fig. 5.1, Item 15), and place it in a suitable collection receptacle.
 The metering pump and all the product-conveying lines in accordance with chapter
"Bleeding the Metering Pump / Manual Functions".
 Connect the suction lance to the new canister.
 Restart the metering pump until the disinfectant reaching the flow monitor is bubble-free.
 Reconnect the flow monitor.
 Exit programming mode again.
417102242_DG_3
If switching to a new product, you must rinse the suction lance, pump and all product-
conveying lines thoroughly with water before connecting the new canister.
If using products that contain glucoprotamin (such as INCIDIN PLUS), the O-rings of the
metering pump piston and piston rods and the O-rings of the flow monitor must be
converted for EPDM (see chapter
button.
2.2 "Intended Use").
- 88 -
Fig. 9.6

Residual quality display

button
8.5.2
Rev.: 02-05.2014