78/88
Bosch Rexroth AG
Functions
8.6.2
Involved parameters
• -Spot "S_0_xx05_PositionReset" (xx stands for the channel / gun number)
8.6.3
Involved signals
• Acknowledge tip dressed
• Position reset
• Ready message tip dress
• Completion message tip test
• Tip dress ok
• Tip wear, geometry wear
• Open gun
• Force reached
• Gun stroke
Note: Signal diagrams can be provided after consultation.
8.7
Referencing
Movements of the gun actuators!
Bruises possible!
Therefore, make sure that can be damaged by movements of the gun
actuators no one.
8.7.1
Function description
• During referencing, the gun move to the rear end stop and then the "Closed
position" is determined.
• Prerequisites for this are loaded and activated parameters, as well as drive and
positioning enable.
• The gun then moves back to the valid setpoint or to the opening position of the
corresponding WeldJob.
8.7.2
Involved parameters
• Spot "S_0_xx04_Referencing" (xx stands for the channel / the gun number)
8.7.3
Involved signals
• Request Referencing
• Referencing without measuring
• Gun is referenced
• Gun is open
• Actual value of gun stroke
• Gun stroke
Note: Signal diagrams can be provided after consultation.
R911405944 | PRC 7x00-Lx/Wx-0200
CAUTION