Weidmuller AC SMART ECO Bedienungsanleitung Seite 99

Networking and configuring the EV charging box
Resetting the EV charging box to factory settings
All settings and data will be reset to factory settings or deleted.
You must be logged in as an Admin. Electrician only!
Prerequisite
The EV charging box may not be connected to a vehicle.
You can reset the EV charging box in the web server or via the power supply.
Resetting the EV charging box in the web server
► Click Config/General.
► Click Start.
► Confirm the reset.
Resetting the EV charging box via the power supply
► Switch the residual current circuit breaker on and off ten times within one
minute.
The EV charging box will be reset to factory settings and restarted
automatically.
Configuring the digital output
You can freely configure the digital output. The following settings are
available:
– The output is switched to be non-functional (continuously 0 V).
– The output puts out a high signal if a charging process is active (status C).
► Click Config/General.
► Select the desired setting.
► Click Save.
Downloading and deleting charging data
You can download the charging data for the charging processes as a csv file.
You can also delete the available charging data.
Downloading charging data
► Click Charging monitoring.
► To download the charging data, click Download.
Deleting charging data
► To delete the charging data, click Delete.
► Confirm the input.
Operating instructions – AC SMART 99