Weidmuller AC SMART ECO Bedienungsanleitung Seite 102

Networking and configuring the EV charging box
102 Operating instructions – AC SMART
9.5 Connecting the EV charging box to an external
device (digital input)
You can connect each of the digital inputs in the EV charging box with an
external switching device.
► Commission an electrician.
► Observe the Assembly and installation instructions.
The input can either be switched by the internal power supply of the EV
charging box (X6.7 and X6.8) or by an external 12 V voltage source with
jointly used GND (X6.6).
If there is a high signal on the selected digital input (logical 1), then the
selected function is executed.
Voltage 0 ... 3 V
Voltage +9 ... +15 V
Each digital input has an input resistance of 2 kOhm and generates a clearing
current of 6 mA at 12 V.
9.6 Starting Bluetooth coupling mode
Via power supply
► If the EV charging box is connected to the power supply, switch the
residual current circuit breaker or circuit breaker off.
► Switch the power supply on after 10 to 12 seconds and then back off after
10 to 12 seconds.
► Switch the power supply on a second time after 10 to 12 seconds and then
back off after 10 to 12 seconds.
► Switch the power supply on a third time after 10 to 12 seconds.
The EV charging box will now be in coupling mode for 5 minutes. The status
LED will flash blue.
After the coupling is complete, coupling mode is ended automatically.
Via integrated web server
► Start the web server, see Chapter 9.3.
► Click Network/General.
► Under Pairing mode, click Start to start coupling mode.
The EV charging box will now be in coupling mode for 5 minutes. The status
LED will flash blue.
After the coupling is complete, coupling mode is ended automatically.
logical 0
logical 1